K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
2023-05-03 09:56:58
jiangxingTools
2012
K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
Grade K40, K42, K44 carbide hobs are mostly used for large production, must be recoated after being resharpened.
Carbide gear hobs are offered with tooth profile DIN 3972 standard Non-Topping or Topping
module rangle for carbide hobs are M0.1-M5, OD Φ16-95, Length 8mm-180mm,bore Φ8-Φ40mm
carbide hobs for finishing cut, pre-grinding, pre-shaving, modified, chamfering, spline shaft, timing pulley, rectangular spline,triangular spline, worm/ratchet,etc special profile.
相關(guān)文章
-
Complete Gear Data for Ordering Gear Hobbing Tools
Complete gear data for ordering gear hobbing tools1, normal module/DP2, No. of teeth3, Normal pressu... - G50/G55 High Speed Carbide Gear Hob with AT Coating
- Timing Pulley Hob for STS 3M
- ?PA20° PCD 240mm Disk Type Gear Shaper Cutter with Big Module m14~m16
- Various Forms of Gear Hobs
- PA20° Module m3 Standard Involute Gear Hob
- Notice for Hob Coating
